# generated by PrusaSlicer 2.4.0-alpha1+linux-x64 on 2021-09-04 at 12:42:23 UTC bed_temperature = 0 bridge_fan_speed = 100 compatible_printers = Trikarus compatible_printers_condition = compatible_prints = Trikarus compatible_prints_condition = cooling = 1 disable_fan_first_layers = 3 end_filament_gcode = "; Filament-specific end gcode \n;END gcode for filament\n" extrusion_multiplier = 0.95 fan_always_on = 1 fan_below_layer_time = 60 filament_colour = #FFFFFF filament_cooling_final_speed = 3.4 filament_cooling_initial_speed = 2.2 filament_cooling_moves = 4 filament_cost = 18.81 filament_density = 1.25 filament_deretract_speed = nil filament_diameter = 1.75 filament_load_time = 0 filament_loading_speed = 28 filament_loading_speed_start = 3 filament_max_volumetric_speed = 0 filament_minimal_purge_on_wipe_tower = 15 filament_notes = "offical data from spool:\n- density: 1.25 g/cm^3\n- diameter: 1.75 mm +/- 0.05 mm (90% of all filament spools below +/- 0.02 mm)\n- print temperature: 205 C +/- 10 C" filament_ramming_parameters = "120 100 6.6 6.8 7.2 7.6 7.9 8.2 8.7 9.4 9.9 10.0| 0.05 6.6 0.45 6.8 0.95 7.8 1.45 8.3 1.95 9.7 2.45 10 2.95 7.6 3.45 7.6 3.95 7.6 4.45 7.6 4.95 7.6" filament_retract_before_travel = nil filament_retract_before_wipe = nil filament_retract_layer_change = nil filament_retract_length = nil filament_retract_lift = nil filament_retract_lift_above = nil filament_retract_lift_below = nil filament_retract_restart_extra = nil filament_retract_speed = nil filament_settings_id = "Trikarus - Redline Filament PLA" filament_soluble = 0 filament_spool_weight = 0 filament_toolchange_delay = 0 filament_type = PLA filament_unload_time = 0 filament_unloading_speed = 90 filament_unloading_speed_start = 100 filament_vendor = (Unknown) filament_wipe = nil first_layer_bed_temperature = 0 first_layer_temperature = 198 full_fan_speed_layer = 0 inherits = max_fan_speed = 100 min_fan_speed = 65 min_print_speed = 10 slowdown_below_layer_time = 5 start_filament_gcode = "; Filament gcode\n" temperature = 198