settings

3D printer Type:
Bed width:mm
Bed height:mm

Print settings Layer height:mm
Wall thickness:mm
Filament thickness:mm
Temperature:degrees C
Bed temperature:degrees C

Speed:mm/s
Travel speed:mm/s
Enable traveling:
First layer slow:
Use sub-layers*:
* Continuously move platform while printing instead of once per layer
Use retraction:
Retraction amount:mm
Retraction min distance:mm
Retraction speed:mm/s

Auto preheat:
Preheat temperature:
Preheat bed temperature:

Doodle3D settings Minimal line distance:px
Max object height:mm
Pixels to mm scale:

Network settings Connection type:

Access point mode Client mode

Access point settings Wi-Fi box ssid*:
* The text %%MAC_ADDR_TAIL%% will be replaced by the last 6 digits of your Doodle3D Wi-Fi box's MAC address.
Password:
Wi-Fi box IP address:
Wi-Fi box netmask:

When you can't connect to your device, you can always use an ethernet cable and go to connect.doodle3d.com.

Client mode settings Wi-Fi box id*:
* Is used on connect.doodle3d.com.
The text %%MAC_ADDR_TAIL%% will be replaced by the last 6 digits of your Doodle3D Wi-Fi box's MAC address.
Network:
Password:

When you can't connect to your device, you can always use an ethernet cable and go to connect.doodle3d.com.

Update

GCODE settings GCode settings for all printers that use Marlin firmware

Start:

End:

The following texts are replaced:

{printingTemp}: Printing temperature
{printingBedTemp}: Printing bed temperature
{preheatTemp}: Preheat temperature
{preheatBedTemp}: Preheat bed temperature

GCODE settings GCODE settings for Makerbots.

Start:

End:

The following texts are replaced:

{printingTemp}: Printing temperature
{printingBedTemp}: Printing bed temperature
{preheatTemp}: Preheat temperature
{preheatBedTemp}: Preheat bed temperature
{printerType}: Printer type

Debug